14 - 3
14.5.2 Nellcor Sat-Seconds Alarm Management
• The SpO
2
Too Low or SpO
2
Too High alarm is presented in the case that SpO
2
value violates the alarm
limits for 3 times within one minute even if the setting of Sat-Seconds is not reached.
14.5.3 Setting SpO
2
Sensitivity (for Masimo SpO
2
)
• When using the Maximum Sensitivity setting, performance of “Sensor Off” detection may be
compromised. If the equipment and the sensor becomes detached from the patient, the potential
for false readings may occur due to environmental noise such as light, and vibration.
14.6 SpO
2
Troubleshooting
• For the physiological and technical alarm messages, see DAlarm Messages.
To Next Page
Loading...
