Replacing the battery
1. Remove integrated key from remote con‐
trol.
2. Slide the key into the opening and raise the
cover.
The battery compartment is accessible.
3. Slide the key in the cover of the battery
compartment and raise the cover.
4. Insert a battery of the same type with the
positive side facing up.
5. Insert lid and cover.
6. Push key into the remote control until it en‐
gages.
Have old batteries disposed of by a
dealer’s service center or another quali‐
fied service center or repair shop or
take them to a collection point.
New remote controls
New remote controls are available from a
dealer’s service center or another qualified
service center or repair shop.
Loss of the remote controls
The lost remote control can be blocked by a
dealer’s service center or another qualified
service center or repair shop.
Emergency detection of remote control
The concept
The engine can be started via emergency de‐
tection of the remote control, if the remote
control is not recognized by the vehicle.
General information
A Check Control message is displayed.
Remote control detection by the vehicle can
among others be malfunctioning under the fol‐
lowing circumstances:
▷ The battery of the remote control is dis‐
charged. Replace the battery, refer to
page 35.
▷ Interference of the radio connection from
transmission towers or other equipment
with high transmit power.
▷ Shielding of the remote control due to
metal objects.
▷ Interference of the radio connection from
mobile phones or other electronic devices
in direct proximity.
▷ Interference of radio transmission by a
charging process of mobile devices, e.g.,
charging of a mobile phone.
Seite 35
Opening and closing
CONTROLS
35
Online Edition for Part no. 01 40 2 969 276 - II/16
To Next Page
Loading...
