6.28 Speed Stamp
Here you can set the Speed stamp.
Options: OFF / ON
6.29 G-sensor Sensitive
The G-sensor is used to detect the 3-axis impacting forces. If any impact over the
threshold value is detected. The current recording file will be locked / protected to avoid
being over-written. Here you can define the sensitivity threshold value.
Options: CLOSE / LOW / MIDDLE / HIGH
6.30 GPS (see 6.39)
Options: ON / OFF
6.31 Speed Unit
Options: Km/H / MpH
6.32 Parking Guard Mode (see 6.40)
Options: Low frame mode / normal mode / OFF / Pre-record mode
6.33 Senior Setting
6.34 Language
Here you can set the language you prefer.
Options: English / 简体中文 / 繁體中文 / Русский
6.35 Default Setting
Here you can restore all the settings to the factory default settings.
Default setting in Menu, options: NO / YES
6.36 Format
Before using, please format the cards in the camera or computer to avoid some
unnecessary troubles. Please check the card icon shown (card A or card B) on screen
carefully before formatting, all files will be lost once you start the formatting process.
After a period of time, We suggest users to format the cards regularly.
(If you are using micro SD card bigger than 32GB, please format the cards on a computer
to be FAT32 format)
Options: NO/YES
6.37 Choose Card
Here you can choose the card which you want to store the videos and photos.
Options: Auto / CARD A / CARD B
If there is only one card in camera body, this card will store videos and photos by default.
If there are two cards in camera body,
1. Here choose Auto, loop recording between card A and card B. Please make sure don’t
To Next Page
Loading...
Need help?
General