6.21 Recycle
This camera supports automatic loop recording when the card is full. Here you can set the
segment length according to your requirement. If you need continuous video without any
segmentation, please set it to OFF but be aware that the maximum video file size is 4GB
and the camera will stop recording once the card is full.
Options: 1 MIN / 3 MIN / 5 MIN / OFF
6.22 Motion Detect
Motion detection is used to reduce the amount of storage space used. When there isn’t
obvious motion detected the camera will switch standby. Once motion over the threshold
value is detected, the camera will start recording and continue until 15 seconds after the
motion stops.
Options: OFF / ON
6.23 Time Setup
Here you can set the Time Zone, system date and time manually. The date/time
information will be automatically updated if GPS satellites are connected.
00 2015 / 01 / 01 12:12
Time zone Date Time
The time zone, corrected for daylight saving time, will need to be set before the GPS
signal can correctly update the time.
6.24 Power off Screen
When camera is standby or recording, you can short press SCREEN button to turn off the
screen to save power at any time, short press SCREEN button again to turn on the
screen.
Or you can set it in the MENU, options are OFF / 10 sec / 20 sec / 30 sec.
6.25 Stamp
Here you can stamp information on video.
Options: OFF / Date Time / Driver Number Stamp
6.26 Drive Number
Here you can define the driver number or your customized information to stamp on the
video (9 characters or numbers).
6.27 GPS Stamp
The camera can record your driving track and stamp the GPS data on video.
Here you can define the GPS data stamping method. Please notice there maybe
electronic interference on GPS signal from camera, radar detector, wireless transmitter,
hardwire kit, car charger, or something else; which will delay the GPS connecting or
mistake the GPS data. An external GPS antenna will help to enhance the reliability.
Options: OFF / ON
To Next Page
Loading...
Need help?
General