The selection lever position P cannot be
changed until all technical requirements are
met.
Engaging selector lever position D, N,
R
A selector lever lock prevents the following
faulty operation:
– Unintentional shifting into selector
lever position R.
– Unintentional shifting from selector
lever position P into another selector
lever position.
1. Press and hold the button to release the
selector lever lock.
2. With the driver's safety belt fastened,
briefly push the selector lever in the de-
sired direction, past a resistance point,
if needed. The selector lever automati-
cally returns to the center position when
released.
Engaging selector lever position P
Press button P.
Rolling or pushing the vehicle
General information
In some situations, the vehicle is to roll
without its own power for a short distance,
for instance in a vehicle wash, or be pushed.
Engaging selector lever position N:
with a latching selector lever
1. Switch on the ignition.
2. If necessary, release the parking brake.
3. Depress the brake pedal.
4. Touch the selector lever lock and en-
gage selector lever position N.
5. Release brake.
The vehicle may roll.
If there is a malfunction, you may not be
able to change the selector lever position.
Manually unlock the transmission lock, if
needed, refer to page 125.
Engaging selector lever position N:
with a tap-operated selector lever
1. Start the engine while pressing on the
brake pedal.
2. If necessary, release the parking brake.
3. Depress the brake pedal.
Seite 122
CONTROLS Driving
122
Online Edition for Part no. 01402723718 - VI/18
To Next Page
Loading...
Need help?
General
