Canada: roadside parking light
Principle
The vehicle can be illuminated on one side.
Turning on
With radio-ready state switched off, press
the lever either up or down past the resist-
ance point for approx. 2 seconds.
Turning off
Briefly press the lever to the resistance
point in the opposite direction.
Welcome lights and pathway
lighting
Welcome lights
General information
Depending on the vehicle equipment and
the ambient brightness, individual lighting
functions may be switched on briefly when
the vehicle is unlocked.
Activate/deactivate
Switch position:
,
Via the Central Information Display (CID):
1. "My MINI"
2. "Vehicle settings"
3. "Lighting"
4. "Exterior lighting"
5. "Welcome lights"
The setting is stored for the driver profile
currently used.
Pathway lighting
General information
The low beams stay illuminated for a partic-
ular time if the high beams are switched on
after radio-ready state is switched off.
Canada: the low beams stay illuminated for
a particular time if the headlight flasher
is switched on after radio-ready state is
switched off.
Setting the duration
Via the Central Information Display (CID):
1.
"My MINI"
2. "Vehicle settings"
3. "Lighting"
4. "Exterior lighting"
5. "Pathway lighting"
6. Set the duration.
The setting is stored for the driver profile
currently used.
Automatic headlight control
Principle
The low beams are switched on and off
automatically depending on the ambient
brightness, for example in tunnels, in twi-
light or if there is precipitation.
General information
A blue sky with the sun low on the horizon
can cause the lights to be turned on.
Seite 146
CONTROLS Lights
146
Online Edition for Part no. 01405A7DAD4 - II/23
To Next Page
Loading...
Need help?
General
