World map with magnetic zones
Procedure
1. Press and hold the adjustment knob for
approx. 3 to 4 seconds. The number of
the set compass zone appears in the mir-
ror.
2. To change the zone setting, press the
adjustment knob quickly and repeatedly
until the number of the compass zone
that corresponds with your location ap-
pears in the mirror.
The set zone is stored automatically. The
compass is ready for use again after approx-
imately 10 seconds.
Calibrating the digital compass
The digital compass must be calibrated in
the event of the following:
– The wrong compass point is displayed.
– The point of the compass displayed does
not change despite changing the driving
direction.
– Not all points of the compass are dis-
played.
Procedure
1. Make sure that there are no large metal-
lic objects or overhead power lines near
the vehicle and that there is sufficient
room to drive around in a circle.
2. Set the currently valid compass zone.
3. Press and hold the adjustment knob for
approx. 6 to 7 seconds so that "C" ap-
pears on the display. Next, drive in a
complete circle at least once at a speed
of no more than 4 mph/7 km/h. If cali-
bration is successful, the "C" is replaced
by the points of the compass.
Seite 216
CONTROLS Interior equipment
216
Online Edition for Part no. 01405A7DAD4 - II/23
To Next Page
Loading...
