Let the compressor run for max. 10 mi-
nutes to fill in the tire sealant and reach
a tire pressure of 2.5 bar/36 psi.
While the tire is being filled with tire
sealant, the tire pressure can briefly
reach approx. 6 bar/87 psi. Do not turn
off the compressor in this phase.
2. Switch off the compressor.
Checking the tire pressure
Read the tire pressure on the tire pressure
display of the compressor. The tire pressure
must be at least 2.5 bar/36 psi.
Tire pressure too high
If the tire pressure is too high, reduce the
tire pressure with the pressure reducing
valve on the compressor.
Minimum tire inflation pressure is not
reached
Do not continue driving unless a minimum
tire pressure of 2.5 bar/36 psi is reached.
Contact an authorized service center or
another qualified service center or repair
shop.
Minimum tire inflation pressure is
reached
1. Pull the connector out of the socket in
the vehicle interior.
2. Disconnect the hose from the sealant
bottle and the valve on the wheel.
3. Unscrew the valve cap.
4. Stow the tire repair set in the cargo
area.
5. Immediately drive 5 miles/10 km to
ensure that the tire sealant is evenly
distributed in the tire.
Do not exceed the permissible maximum
speed of 50 mph/80 km/h.
If possible, do not drive at speeds less
than 12 mph/20 km/h.
Tire sealant may spray from the dam-
aged area during the initial wheel rota-
tions.
Adjusting the tire pressure
1. Stop at a suitable location.
2. Connect the hose directly to the com-
pressor and turn clockwise by 90° until
it audibly engages.
3. Unscrew the valve cap from the wheel
and screw the connecting piece of the
hose onto the valve.
Seite 264
MOBILITY Wheels and tires
264
Online Edition for Part no. 01405A7DAD4 - II/23
To Next Page
Loading...
Need help?
General
