4. Pull the wiper blade down out of the
holder on the wiper arm, arrow 1.
5. Pull the wiper blade free from the holder
of the wiper arm, arrow 2.
6. Insert and lock a new wiper blade in
reverse order.
7. Fold in the wiper arm.
Replacing the rear wiper blade
1. Fold out and hold the wiper arm firmly.
2. Turn back the wiper blade to the stop.
3. Push the wiper blade out of the fasten-
ing by continuing to turn it to the stop.
4. Insert the new wiper blade by following
the steps in reverse order. The wiper
blade must engage audibly.
5. Fold in the wiper arm.
Light and bulb replacement
General information
Lights and bulbs
Lights and bulbs make an essential contri-
bution to driving safety.
Except for the reversing light, all headlights
and lights are designed in LED technology.
The vehicle manufacturer recommends hav-
ing necessary work performed by an au-
thorized service center or another qualified
service center or repair shop if you are un-
familiar with performing this work or if it
has not been described here.
A replacement bulb set is available from an
authorized service center or another quali-
fied service center or repair shop.
Follow the safety information, refer to
page 284.
Light-emitting diodes (LEDs)
Some items of equipment use light-emitting
diodes installed behind a cover as a light
source. These light-emitting diodes are re-
lated to conventional lasers and are offi-
cially designated as Class 1 light-emitting
diodes.
Follow the safety information, refer to
page 284.
Safety information
Lights and bulbs
Warning
Bulbs can get hot during operation. Con-
tact with the bulbs can cause burns. There
is a risk of injury. Only change bulbs after
they have cooled off.
Seite 284
MOBILITY Replacing components
284
Online Edition for Part no. 01405A7DAD4 - II/23
To Next Page
Loading...
Need help?
General
