Manual MiniFlex 298330863 rev 0 page 6 from 34
Keep all electrical connections dry and do not place them on the ground.
Touching the equipment or plugs with wet hands can increase the risk of
electric shock.
Handle the adapter cord with care. Never use the adapter cord to lift the
tool, pull it or unplug the adapter with the adapter cord. Keep the adapter cord
away from heat, oil, sharp corners or moving parts. Damaged or tangled cords
increase the risk of electric shock.
If use of the unit in a damp location cannot be avoided, use a power
supply protected by means of a ground fault circuit interrupter. Use of an
earth leakage circuit breaker reduces the risk of electric shock.
Charge only with the original adapter specified by the manufacturer. An
adapter suitable for a particular type of battery may result in a risk of fire if
used with other batteries.
Do not cover the adapter during use. Proper ventilation is required for
proper use. Covering the adapter may result in a fire.
Use the device and adapter in dry places with proper temperature in
accordance with the documentation. Extreme temperatures and humidity
may damage the batteries and result in leakage, electric shock, fire or burns.
The adapter is not waterproof and is intended for indoor use only. To
prevent electric shock, do not use the system outdoors or in wet conditions
with an adapter.
Do not insert any conductive objects into the batteries. Shorting between
the terminals of the battery may cause sparks, burns, fire or electric shock.
The device is not designed to provide protection and insulation from
high voltage. Do not use if a high voltage contact hazard is present
The system operates on a voltage of 100-240V/50-60Hz and/or on the
built-in battery. Make sure the system is always in a dry environment and set
up indoors. The camera head is obviously waterproof.
If you want to use a genset, make sure that the genset provides a stable
supply voltage that is within the adapter's operating range. If in doubt, do
not use a genset. Using the wrong and/or unstable voltage will cause serious
damage to the system and will void your warranty.
We recommend not using a generator.
If you are using an inverter (12V DC to 230V AC). The output voltage
(230V AC) must be a pure sine wave. Your dealer can help you select a
proper inverter to suit your system. Using an inverter with too little power or
with a non-pure sine wave as output signal can cause major damage to your
system. This will void the warranty.
To Next Page