Minivator 1000 - Operating toggle; Remote control; Folding your stairlift

Operating your Minivator 1000
Operating toggle
5
Figure 6
Operating your Minivator 1000
The remote contr
ol (Figure 7) is used to
call the lift to either the top/bottom of the
stairs or to operate a powered folding
hinge where fitted. This control may also
be used by an attendant where the user is
unable to operate the stairlift themselves.
The attendant should always r
emain off
the staircase until the stairlift is
stationary.
Your Minivator 1000 seat, ar
mrests and
footrest can be folded (when not in use)
to allow easier passage up and down stairs
(Figure 8).
SAFETY PRECAUTION!
ALWAYS RETURN THE STAIRLIFT TO ITS
STOWED POSITION. I.E. WITH ARMRESTS,
SEA
T AND FOOTREST FOLDED AND THE
CHAIR PARALLEL TO THE TRACK AS
SHOWN IN FIGURE 8, SO THA
T EXITS ARE
NOT OBSTRUCTED.
Manual footplate link (optional)
If your stairlift is fitted with a manual
footplate link the footplate will
automatically fold away when the fr
ont
seat squab is lifted. It will also lower the
footplate when the front seat squab is
lower
ed.
Power footplate link – seat squab
operated (optional)
If your stairlift is fitted with a power
footplate link operated fr
om the seat
squab it will automatically fold away the
footplate when the fr
ont seat squab is
lifted. It will also lower the footplate when
the front seat squab is lowered.
Power footplate link – arm operated
(optional)
If your stairlift is fitted with a power
footplate link operated from the arm it
will have an additional switch under the
ar
m (Figure 9). To lower the footplate, use
the rocker switch under the arm.
To lift the footplate move the rocker
switch to its alter
nate position.
NB If moving the footplate while seated on
the stairlift please ensur
e your feet do not
obstruct the footplate whilst it is in motion.
Remote control Folding your stairlift
6
Figure 7 Figure 8
Your Minivator stairlift is operated by
simply pressing and holding the operating
toggle in the direction you wish to travel
(Figure 6). The stairlift will automatically
stop when the toggle is released or the
stairlift has r
eached the end of its travel.
PLEASE NOTE:
In the inter
est of safety, initial activation of
the stairlift is delayed by 1 second from
pressing and holding the operating toggle,
to avoid accidental operation. If the toggle
is r
eleased while the lift is in motion, the
lift will stop and a delay of 1 second will
occur before the toggle will re-start the lift.
When changing the direction of travel the
delay will be 3 seconds before the lift
begins to move.
Figure 9
ENGLISH