Overview
Power LED - The LED glows blue when NEO J50C-4 Max is on.
Power Button - To power on the NEO J50C-4 Max, press and
hold the power button for 1-2 seconds until the power
LED glows. To power off the NEO J50C-4 Max, press and hold
the power button for 8 seconds.
3.5mm Audio Jack + S/PDIF Port - Connect an external audio
input/output device such as microphone or AV receiver etc.
Gigabit Ethernet Port - Connect an Ethernet cable for
wired internet access up to 1000Mbps.
DC 12V Power-in Jack - Connect the included 12V power
adapter. NEO J50C-4 Max requires approx. 1A to operate,
however the included power adapter provides 3A to ensure
support for other external devices attached to
NEO J50C-4 Max, such as an external hard drive.
To Next Page
Loading...
