MINN KOTA MICRO REMOTE User Manual

4 | minnkota.johnsonoutdoors.com
©2023 Johnson Outdoors Marine Electronics, Inc.
PAIRING THE MICRO REMOTE TO YOUR CONTROLLER
PAIRING THE MICRO REMOTE TO YOUR CONTROLLER
a. Power up the trolling motor.
b. Locate the Pair
PAIR
button at the top of the
Control Head.
c. Push and hold the Pair
PAIR
button down. A consistent
tone will be emitted from the
Control Head.
d. While holding the Pair
PAIR
button on the Control
Head, push and hold the Max Speed
and
AutoPilot
buttons on the remote simultaneously.
NOTICE: When the remote is being paired to the
Controller, the Max Speed
and the AutoPilot
buttons need to be held down simultaneously.
Make sure to also hold the Pair
PAIR
button on the
Control Head to successfully pair the remote to
the controller.
NOTICE: A remote can be paired to one controller at a time.
A controller can have multiple remotes paired to it.
PAIR
Pair Pair
ButtonButton
Max SpeedMax Speed
AutoPilotAutoPilot
e. Once successfully paired, 3 longer beeps will be
emitted from the Control Head and the remote will
be paired.
The controller is located in the Control Head on your Minn Kota trolling motor with Advanced GPS Navigation and may pair up to 5
remotes. These five remotes can be a combination of standard remotes and micro remotes. Any additional remotes can be paired using
the following steps. Once the maximum number of remotes have been paired, the controller will start replacing the oldest paired remote
in memory with the new remote.
NOTICE: Make sure the remote stays within range of
the Control Head during the pairing process.
1
2

MINN KOTA MICRO REMOTE Specifications

General

Brand	MINN KOTA
Model	MICRO REMOTE
Category	Remote Control
Language	English