Minolta Auto Winder G - Caution; Note

winder will advance the f ilm after
each one at a
rate
of
up to two
f rames
per
second. In either
single-frame or continuous
opera-
tion,
the
pilot
light will come
on
during
each advance cycle.
3.
At the end of each cartridge, the
winder
will
automatically stop,
and
the
pilot
light will stay lit.
CAUTION
Do
not
release
the
battery
holder
while
the
winder is operating as
this
could interrupt the
winding cycle. lf
this
happens
and
replacing the
hold-
er does not restore winder
opera-
tion, cock the shutter once
manually
using
the
film-advance lever. The
winder
mechanism
should
then be
recycled,
and
normal
operation
can
be resumed.
NOTE
o
Excess tension on the film may
stop the
winder
drive mechanism
in
mid-cycle before
the
film
is
exhausted; the
pilot
light will
also
remain lit. Should this happen,
move
the
winder's
power
switch
to
"OFF"
and then to
"ON."
This
should
reset the
winder
and
pilot
light
for normal
operation.
ff the
winder
still
does not
oper-
ate,
replace
the
f ilm cartridge
and/or
batteries.
o
When the camera's
shutter-speed
selector
is set at
"B" the
winder
will advance
after
the operating
button is released.
o
During
winder operation,
the
advance
lever
should
be
kept at its
rest
position.
a
Keep the
winder's
power
switch
at
"OFF"
when the
winder
is not
being
used.