(2720)A 1
REPAIR GUIDE
This repair guide section contains the disassembly and adjustment procedures.
For the assembly procedure, follow the reverse procedure.
SYMBOLS
■:Cautions and keypoints
: Grease
: Adhesive
: Tool
CONTENTS Page CONTENTS Page
Precautions------------------------------------------------- 2
Discharge --------------------------------------------------- 3
1. Disassembly of the exterior parts ------------------ 4
2. Disassembly of the compl PWB TB-3, LCD------ 8
3. Disassembly of the assy cabi front,
compl PWB TB-3/CA-2/TC-1 ---------------------12
4. Disassembly of the compl PWB SY-1/
ST-1/PW-1/TB-1/SY-2/DM-1 ----------------------18
5. Disassembly of the CCD holder assy,
the outer barrel assy and the 1st lens group
moving barrel. ---------------------------------------22
6. Disassembly of the outer barrel assy -------------25
7. Disassembly of the 4th moving barrel assy,
the 3rd moving barrel assy and the 2nd lens
group assy. ---------------------------------------------27
Arrangement plan of PCB -----------------------------29
Required adjustment, setting and confirmation
items after repairing (exchanging parts) --------30
Related adjustment and required setting items --- 31
Preparing the 2782 adjustment program-----------32
Starting up the 2782 adjustment program
(in the adjustment mode). -------------------------- 33
Contents of the adjustment program and CPU
version readout ----------------------------------------34
Setting the camera and the chart when
adjusting the CCD perspective.--------------------35
Adjustment of CCD perspective-----------------------37
Sensitivity adjustment (GAIN) -----------------------39
Adjusting the center part of CCD
(CCD CENTER) ---------------------------------------40
Adjustment of the frequency for camera shaking
(ACT DRV FREQ) ------------------------------------41
Adjustment of the servo for camera shaking
(SERVO GAIN)----------------------------------------41
Adjustment of the gyro for camera shaking
(GYRO OFFSET) -------------------------------------42
Adjustment of the shutter (SHUTTER) -------------43
Adjustment of the defective pixel
(DEFECT PIXEL) ------------------------------------43
Adjustment of the flash GN (FL GNo) --------------44
Adjustment of white balance (WB) -------------------45
Adjustment of the focus (FCS INF POS) -----------46
Adjustment of the manual focus PI (MF PI) -------47
Adjustment of the camera shaking compensation
(SHAKE OFFSET) -----------------------------------48
DESTINATION Setting (DESTINATION) --------49
Setting date and time (TOD) --------------------------49
Error code on adjustment program ------------------50
Measuring instrument----------------------------------51
Subsidiary Materials ------------------------------------52
To Next Page
Need help?
General
