42 (2720)A
REPAIR GUIDE
■■
■■
■
Fig. 1Fig. 1
Fig. 1Fig. 1
Fig. 1
Adjustment of the gyro for camera shaking (GYRO OFFSET)
Required equipment
PC with preinstalled the 2720 adjustment program
USB-500 (USB cable)
AC-1L/AC-11
Preparation of the adjustment
1. Start up the 2720 adjustment program.
2. Connect the camera and PC with USB-500, and click "START" after confirming the USB connection.
3. Set the lens block of the camera to "Wide-angle" position.
Procedure of the adjustment
1. Click "GYRO OFFSET" of the adjustment menu.
The adjustment is automatically started.
2. The adjustment is completed when "OK" is displayed on the adjustment menu.
Camera:Camera:
Camera:Camera:
Camera:
Lens block: Wide-angle positionLens block: Wide-angle position
Lens block: Wide-angle positionLens block: Wide-angle position
Lens block: Wide-angle position
Luminance boxLuminance box
Luminance boxLuminance box
Luminance box
：：
：：
：
Brightness: EV14Brightness: EV14
Brightness: EV14Brightness: EV14
Brightness: EV14
Adjustment of the shutter (SHUTTER)
Required equipment
Luminance box
L-2101/L-2111 or multi camera tester: EF-8301
PC with preinstalled the 2720 adjustment program
USB-500 (USB cable)
AC-1L/AC-11
Preparation of the adjustment
1. Start up the 2720 adjustment program.
2. Connect the camera and PC with USB-500, and click "START" after confirming the USB connection.
3. Set the camera and the measuring instrument as shown on the Fig.1.
4. Set the luminance box to "EV14," and the lens block of the camera to "Wide position."
Procedure of the adjustment
1. Click "SHUTTER" of the adjustment menu.
The adjustment is automatically started.
2. The adjustment is completed when "OK" is displayed on the adjustment menu.
To Next Page
Loading...
Need help?
General
