Minolta CS-100A User Manual

11
Command TDR
Function Outputs the target value for measuring color difference memo-
rized in the main body.
Control side Ë this product format "TDR"
This product Ë control side format "OK00,  ,D ,D "
Control sideËthis product format details Command only
This productËcontrol side format details @ Following the error check command, outputs target luminance value Y,
target chromaticity value x, target chromaticity value y.
Command UCR
Function @Outputs the standard value for measuring user calibration
standard memorized in the main body.
Control side Ë this product format "UCR"
This product Ë control side format "OK00,  ,D ,D "
Control sideËthis product format details Command only
This productËcontrol side format details @ Following the error check command, outputs luminance standard value Y,
chromaticity standard value x, chromaticity standard value y.
Command TDS
Function @Memorizes the measured value held in the main body as the target
value for measuring color difference in the main body.
@
Depending on whether the measured value is held or on the condition
of the measured value held in this product, an error may occur.
Ë In case not to be calculated and memorized [normally]
When luminance and chromaticity measuring range over (same as E0 display)
When chromaticity measuring range over (same as  E0 display)
When luminance display range over (same as E9 display)
In case that the measured value is not held (same as E display)
Control side Ë this product format "TDS"
This product Ë control side format @In case to be calculated and memorized normally
"OK00"
@In case not to be calculated and memorizes normally
"ER01"
Control sideËthis product format details Following the command, outputs target luminance value Y, target
chromaticity value x, target chromaticity value y.
This productËcontrol side format details @In case to be calculated and memorized normally
Outputs the error check command only.
@In case not to be calculated and memorizes normally
Outputs the error check command "ER01".

Minolta CS-100A Specifications

General

Brand	Minolta
Model	CS-100A
Category	Measuring Instruments
Language	English