14
Memory and recall of set data
In the RS mode the color difference target data and the user calibration
standard data can be inputted and outputted in valid numeral of 4 digits.
In case to recall the set value memorized in the RS mode in the normal
measuring mode, the fourth digit of the valid numeral is rounded off and
displayed in 3 digits.
(The valid numeral up to 4 digits is used for calculation.)
In case to memorize the color difference target data and the user calibra-
tion standard data in the normal mode, [0] comes instead of the fourth
digit of the valid numeral.
Therefore, in case to read out the set data memorized in the normal mode,
the fourth digit becomes always [0].
To Next Page
Loading...
Need help?
General
