D-87
(7) Lead Edge Erase
Requirement
This adjustment must be made after the PH Unit has been replaced and following Registra-
tion (CD/FD).
Adjustment Procedure
1. Call the Adjust mode to the screen.
2. Touch [Printer].
3. Touch [Lead Edge Erase].
4. Press the Start Key to let the copier produce a test pattern.
5. Check to see if width A on the test pattern is up to the specifications. If it is outside the
specified range, perform the following adjustment steps.
Specification Adjust Mode Setting Range
3.0 ± 1.0 mm Lead Edge Erase 0 to 5
Width A on the test pattern output should fall within the
following range.
NOTE
The measurement shall be taken at the center on the
leading edge of the paper.
1155D156AB
To Next Page
Loading...
