Minolta DI450 - Page 107

D-88
Setting Instructions
If width A is longer than the specifications, make the setting value smaller than the current
one.
If width A is shorter than the specifications, make the setting value greater than the current
one.
8. Press the Start key to let the copier produce a test pattern.
9. Check to see if width A on the test pattern is up to the specifications.
If it is outside the specified range, change the setting value and make a check again.
10. If width A falls within the specified range, touch [END] to validate the setting value.
6. Press the Clear key to clear the current
setting value.
4
7
5
8
0
3
6
9
C
4002D519AA
Usetoclearthe
setting value.
Usetoenterthe
setting value.
7. Use the 10-key pad to change the setting
value.
4002D512CB
Setting Value