D-33
(4) Cleaning of the Scanner Rails/bushings
(5) Cleaning of the PH Glass
(6) Removal of the Scanner
1. Remove the Original Glass.
2. Wipe clean the Scanner Rails/bushings with a soft
cloth.
NOTE
Apply lubricant to the Scanner Rails/Bushings after
they have been cleaned.
4002D100AA
1. Swing down the Front Door and slide out the
Developing Unit.
2. Open the cover.
4002D265AA
3. Wipe clean the PH Glass with a soft cloth.
4002D099AB
1. Remove the Original Glass.
2. Slide the Scanner to the position shown.
3. Remove the two Scanner mounting screws at the
front and rear.
4002D101AC
To Next Page
Loading...
