Minolta DYNAX 5 - Page 110

40 A(2163) —
@
Fig
5
@
Fig
6
Hook
the
tip
of
BACK
COVER
LOCK
SP
as
Holding
SAFETY
LOCK
DEIVE
LEVER
in
arrow
illustrated.
direction,
and
install
SAFETY
LOCK
Mm Fig. 7
REPARGUIDE
=|
1, Insert the shaft of SAFETY LOCK SWITCH LEVER to the oval hole of SAFETY LOCK BASEPALTE
ASSY, and fit BACK COVER LOCK JOINT LEVER between the lever and the projection of SAFETY
LOCK SWITCH LEVER.
3, Hold the tip of SAFETY LOCK SWITCH LEVER SP along SAFETY LOCK SWITCH LEVER, then install
to SAFETY LOCK BASEPALTE ASSY.
3. Fit the belee of SAFETY LOCK DETECT CONTACT-A to the posts of SAFETY LOCE CHANGEOVERE
CAM, SAFETY LOCK BASEPALTE ASSY and SAFETY LOCK SWITCH LEVER.
Make sure the SAFETY LOCK DETECT CONTACT-A dose not go over SAFETY LOCK SWITCH LE-
VER.
4. Hook the tip of SAFETY LOCK SWITCH LEVER to the post of SAFETY LOCK BASEPALTE ASSY.
p sure the SAFETY LOCK DETECT CONTACT-A
dose not go over SAPETY LOCK SWITCH LEVER.