Minolta DYNAX 5 - Page 111

(2163)A 41
m Fig. 5
Fit the contact of SAFETY LOCK DETECT CONTACT-B to the groove of SAFETY LOCK CONTACT HOLD
CONTACT HOLD PLATE
SAFETY LOCK DETECT CONTACT-B
m Fig 9
i. Turn SAFETY LOCKE DRIVE LEVEE in arrow direction to set SAFETY LOCK SWITCH LEVER to the
lower position.
2. Turn the BACE COVER LOCK RELEASE LEVER SP in arrow divection to charge the spring, and hook
it t SAFETY LOCK BASEPLATE ASSY as illustrated.
&. Insert the tip of BACK COVER LOCE EELEASE LEVER between SAFETY LOCKE BASEPLATE ASSY
and SAFETY LOCK SWITCH LEVER.
4. Hook the longer tip of BACK COVER LOCK RELEASE LEVER SP to the notch BACK COVER LOCK
RELEASE LEVER, then slide BACK COVER LOCK RELEASE LEVER in arrow direction.
(Bafety lock release position} ae BACK COVER LOCK
BACK COVER LOCK RELEASE LEVER RELEASE LEVER SP
BdINOuWdSaN
|
@ Fig. i8
Stick #2162-1162 to the designated position.
2162-1152