Minolta MAXXUM 3xi - Removing

Ren ii'if
1. Press the lens release and hold it
in while you turn the lens counter- ^
clockwise until it stops. Lift the lens
out of the mount.
2. Immediately attach the rear cap to
the lens and the body cap or another
lens to the camera. This will protect
the lens elements, lens contacts,
and camera interior.
Care of Glass Surfaces
* Never touch any lens surfaces (including the eyepiece) with your fingers. If
8 lens becomes dirty, first gently clean it with a lens brush. Then, if necessary,
moisten a sheet of lens tissue with one drop of lens-cleaning fluid and,
starting from the center of the lens, wipe the glass using a circular motion.
• Never lift the mirror or touch its surface. This may impair its alignment or
scratch its face. Dust on the mirror's surface will not affect meter readings or
picture quality. If it is distracing, have the camera cleaned at an authorized
Minolta service facility.
11