CUSTOM FUNCTIONS
9392
Mid Reload
Mid Reload decreases the chances of accidental double exposure when reloading a
partially exposed roll of film.
• Reloading a partially exposed roll increases the risk of film damage (scratches) caused by
dust and grit.
1. Set custom function 3 to setting 3 .
2. Load the film (p. 15).
• The film is automatically advanced to frame 1.
3. Open the control panel door, then
press and hold the adjust button
until 1 blinks in the data panel.
4. Turn either control dial until the
frame number you want to advance
the film to blinks in the data panel.
• Advance the film a minimum of two frames past
the last exposed frame.
5. Press the adjust button.
• The film is automatically advanced to the desired
frame.
Cust 1 — AF/Release priority
1 – AF priority
Shutter will not release until or appears in the viewfinder.
2 – Release Priority
Shutter releases even if the focus cannot be confirmed.
Use release priority when photographing moving
subjects.
• RP will appear in the data panel.
Cust 2 — Film Rewind Start
1 – Automatic
Film is automatically rewound at the end of the roll.
2 – Manual
User must press the manual-rewind button to initiate rewind (p. 24).
Cust 3 — Film Tip
1 – Film is completely rewound into the cartridge.
2 – Leader is left out of the cartridge after rewind.
3 – Leader left out after rewind. / Camera setup for Mid Reload.
SPECIAL FUNCTIONS
To Next Page
Loading...
