EasyManua.ls Logo

Minolta Maxxum 9 - Exposure Compensation

Minolta Maxxum 9
59 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
97
Cust 11 — Bracketing Sequence
1 – Metered exposure, Underexposure(s), Over-exposure(s)
A 5 frame bracket in 1/2EV increments is exposed in the following order…
Normal -0.5EV +0.5EV -1.0EV +1.0EV
2 – Underexposure(S), Metered exposure, Over-exposure(s)
A 5 frame bracket in 1/2EV increments is exposed in the following order…
-1.0EV -0.5EV Normal +0.5EV +1.0EV
Cust 12 — Rewind Speed
1 – Fast Rewind
Rewinds a 36 exposure roll in approximately 6 seconds.
2 - Slow (silent) Rewind
Rewinds a 36 exposure roll in approximately 9 seconds.
96
Cust 9 — AF Button
1 – Selectable focus area
Press the AF button and turn the control dial to
specify the desired local focus area. See page 31 for
details.
2 – Spot Focus
Press the AF button to focus using the center focus
sensor (p. 31).
Cust 10 — AE-Lock Button
1 – Press to activate, release to cancel.
2 – Press once to activate, press again to
cancel.
Turning the built-in flash on or off cancels AE lock.
AEL appears in the viewfinder when AE-lock button is active (down).
Slow sync is selected when the built-in flash is up or an attached accessory flash is on.
Manual shift is selected when the exposure mode is set to manual.
Cust 8 — Frame Counter
1 – Frame counter in data panel counts up.
2 – Frame counter in data panel counts down.
The frame counter counts up when non-DX coded film is loaded.
CUSTOM FUNCTIONS
SPECIAL FUNCTIONS

Related product manuals