101101
If the camera is not connected to a
PICTBRIDGE™ compatible printer, the
following error message will appear on the
LCD.
Connection Failed!
The error message above will also
appear if the USB mode is set
incorrectly, in which case you should
disconnect the Micro USB cable, check
the USB mode settings, ensure that
the printer is turned on, and then try
connecting the Micro USB cable again.
1. Make sure the printer is turned on.
2. Connect one end of the supplied Micro
USB cable to the Micro USB port on your
camera.
3. Connect the other end of the cable to the
USB port on the printer.
Connecting to your Printer
To Next Page
Loading...
