61
PRINT QUANTITY SELECTION
60
PRINT-QUANTITY SELECT
With print-quantity select, you can choose the number of prints you will receive from the
lab before taking the picture. If someone walks into the picture at the last moment or you
change your mind, the print quantity can be zeroed after the picture is taken.
Setting the Print Quantity
Before taking the picture -
1.Press the print button to enter the desired
number of prints.
• The quantity will be displayed on the data panel.
• Press the print button to increase the quantity by one.
• The quantity can be set to a maximum of nine. After 9,
the quantity restarts at 1.
2.Press the shutter-release button all-the-way
down to take the picture.
• The quantity is reset to one for the next frame.
• Only one frame is actually exposed.
To Next Page
Loading...
