19
INSTALLING THE BATTERY
18
INSTALLING THE BATTERY
Your camera uses one 3-volt CR2 lithium battery to supply power for all camera operations.
1. Using a coin or similar object, turn the battery-chamber
lock to OPEN, then open the battery-chamber door.
2. Insert a new battery into the chamber as indicated by
the + and – marks.
3. Close the battery-chamber door and turn the battery-
chamber lock to CLOSE.
• Reset the date and time after installing a new battery.
Important – Before opening the Battery Chamber
• Wipe all water, sand, and grit off of the camera.
• Do not open the battery chamber in places where water, blowing sand, or dust can enter the camera.
• Make sure the battery is clean and dry before inserting it into the camera.
• To prevent condensation from forming, let the camera come to room temperature before opening the
film or battery chambers when bringing the camera into a warmer environment.
2208_E 24/10/97 10:29 AM Page 18
To Next Page
Loading...
