Minolta X-7A - Page 37

Flash sync and control : Hot shoe for X sync; camera-
cont r ol contact on hot shoe for automatic setting of
shutter at 1/60 s ec . (except when mode/shutter -speed
selector at
"B") and flash-ready signaling wi t h X- and
PX-series
Auto Electroflashes; other electronic flashes
s
ynchronize at 1/60 se c. and slower manual speeds or
" B" setting; Class MF , M, and FPflashbulbs, at 1/15 sec .
or slower setting
Film advance: Manaul : by lever with single 130
0
stroke
after 30
0
unengaged movement ; motorized with acces-
s
ory Motor Drive 1 or Auto Winder G; release button
fo r rew ind on camera bottom; advancing-type frame
counter ; Safe Load Signal indicating film loading and
advancing
condition
Power: Two 1.5v alkaline -manganese (LR44 : Eveready
A-76
or equiv.), two 1.55v silver-oxide (SR44: Eveready
S-76, EPX-76
or equiv.), or one 3v lithium (CR-l/3N)
cell(s) power both auto exposure control and manual
oper
at i on ; main switch wi th indicat ion for off or on ;
mode
LED blinks when cells approach exhaustion ; no
LEOs light and shutter will not release when voltage is
too low for proper operation
Self-timer : Electron ic for 10 - sec. delay, with operation
indicated by camera-front LED that blinks at 2Hz for 8
sec ., then 8Hz for 1 sec ., then remains on unt il shutter
releases, cancelable anytime before release
Other : Integral front handgrip ; back · with memo holder,
and ISO (DIN'ASA) table; pOSitive 4- slot take-up spool;
remote shutter-release socket
Size and weight: 137 x 90 x 51.5mm (5-3/8 x 3- 9/16 x
2 in.
). 470g (16-9/16 oz.) without lens and power cell(s)
Standard accessories; Carrying strap with slide-on bat-
tery holder and eyepiece cap
Optional accessories: Minolta Auto Electroflashes; Motor
Drive 1, Auto Winder G; Wireless Controller IR -l Set;
MD , MC, and other Minolta interchangeable lenses and
applicable Minolta SLR system accessories
Specifications subject to change without notice
35