film winds onto the take-up spool, it
pushes forward a lever inside the take-up
chamber. The lever then moves the film-
advance indicator from left to right in Fig.
28. You can see the film-advance in
dicator through the window at the back
of the top cover.
Check the film-advance indicator after
you replace the retaining ring around the
wind shaft. Fig. 24. Reach to the front of
the take-up spool and push forward the
lever that extends into the take-up
chamber; the film-advance indicator
should move into the window. If the film-
advance indicator doesn't move, loosen
the retaining ring. Fig. 24. Then hold for
ward the lever inside the take-up chamber
so that you can see the film-advance in
dicator within its window. Continue
holding the lever as you tighten the re
taining ring.
To replace the wind lever, first hook its
hole to the end of the wind-lever return
spring. Then rotate the wind lever in a
counterclockwise direction as you seat it
over the wind shaft. The upper coil of the
wind lever return spring sometimes
sneaks under the wind lever. If that hap
pens, the wind lever won't return freely
after you replace the cover screw.
The film-speed dial can also be tricky to
install. Replace the exposure-compensation
lever and the detent rack as shown in Fig.
29; notice that the slot in the exposure-
compensation lever fits over the tab on the
film-speed resistor ring. Then replace the
black plastic decorator ring. Fig. 25. The
notch in the decorator ring goes under the
exposure-compensation lever.
SPEED KNOB
RETAINING RING
TOP COVER
RETAINING RING
MODE SELECTOR
Figure 24
mmo
EXPOSURE CO MPENSATION
LEVER /
LONG TOP-COVER
SC RE W S I
DETENT
PLATE
FRONT-
DECORATOR
PLATE v
UPPER
BRASS
BUSHING
DECORATOR
RING
Figure 26
EYEPIECE-BLIND LEVER
TOP-COVER
SCREW
-----
MO DE SWITCH
IN M MODE
A MODE
Figure
To Next Page
Loading...
