Minolta XG-1 User Manual

10 ATTACHING AND REMOVING LENSES
To Attach
1.
Remove the body cap from the camera lens
mount and the rear cap from the lens
bayonet, each by turning the cap counter-
clockwise.
2. Align the red mounting index on the lens
barrel with the red index above the camera
lens
mount; insert the lens bayonet into the
mount; and turn the lens clockwise until it
locks into place with a click .
To Remove
While pushing the lens-release button, turn
the lens counterclockwise as far as it will go;
then lift the lens bayonet out of the mount .
CAUTION
If it becomes necessary to set the lens down
without a rear lens cap attached, be sure to set
the lens only on its front end (except for
fisheye lenses) as damage to the diaphragm
control pin could result from rear lens contact
with a hard ·surface.

Minolta XG-1 Specifications

General

Lens Mount	Minolta MD
Exposure Metering	Center-weighted average
Flash Sync	1/60 sec
Type	35mm SLR
Shutter Speed	1 sec - 1/1000 sec, Bulb
Film Speed	ASA 25-1600
Viewfinder	Fixed eye-level pentaprism
Battery	Two 1.5V LR44 or SR44