Minolta XG-1 - Page 53

LED at "60" position also blinks as flash-ready signal with the X-series
Auto Electroflashes
Flash sync:
PC terminal and hot shoe for X sync. (disconnect when unit not installed) :
Electronic flash synchronizes at 1/60 sec. and slower step or stepless
speeds ;
Class MF , M, FP flashbulbs synchronize at 1/15 or slower speeds.
Extra contact on hot shoe receivers signal from camera-control contact of
the X-series Auto Electroflashes
Film advance: Motorized: Through built-in coupler key with accessory Auto Winder G
Manual:
By lever with single 130° stroke after 30° unengaged movement
Film -advance release button for rewinding; advancing-type frame counter
and Safe Load Signal that indicates film loading and advancing conditions
Power: Two 1.Sv alkaline-manganese or silver-oxide (Eveready EPX-76/S-76 or
equivalent) cells power both auto exposure control and shutter's electron-
ically governed operation
LE 0 battery check indicator lights when operating switch in battery check
posit i on
Shutter will not release when voltage too low for proper operation
Self- timer : Electronic, LED indicated types; approximately 10 sec. delay
Other : 4-slot take-up spool; back cover with ASA-OIN conversion scale
Size and
weight : 52 x 88 x 138mm (2 x 3-7/16 x 5-5/8 in.)
490g (17-5/16 oz.) without lens and power cells
Accessories: Exclusive
Auto Winder G, Auto Electroflash 320X , 200X, 132X and 118X ,
Remote Cord S SOcm (20-in.) and Remote Cord L Sm (16-ft.) ; MO, MC,
and other interchangeable Minolta lenses and applicable Minolta SLR
system accessories
51