FRONT PANNIER RACK
(ver.1.2 2014/6)
instructions manual
MT-4000SF
MINOURA JAPAN
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone +81-584-27-3131 / Fax +81-584-27-7505
minoura@minoura.jp www.minoura.jp
Installation of this product requires removal and re-installation of the front wheel quick release
skewer that is one of the most important parts on your bike for safety reasons.
If the process was not done properly, it may cause a serious accident that the front wheel will
come off from the front fork while riding.
You must ask to a well educated mechanic who has enough knowldge and good experience
on this kind of job if you are not condent on doing it by yourself.
Minoura will not be responsible with any result that has been caused by your own work.
This rack can be installed on the standard front suspension fork which bottom tube diameter
is between 38mm and 40mm. Any other size is not suitable, including plain rigid fork and
inverted type suspension fork. If you wish to install onto outsize fork, do it at your own risk.
Max load capacity of this rack is 15 kgs.
!
Important Notes
Contact:
MT-4000SF
49 44924 010690
(Example: Installed on a MTB)
This product is a front luggage rack
for bicycle with suspension fork.
Not for use with a rigid fork.
The rack is designed to be compatible
with a standard pannier bag.
The bag attaches to the rack frame
with its top hooks which inner width
is 10mm.
Read these instructions carefully
before installing for your safety.
Made in Japan
Warranty Period :
1 year
after purchase
To Next Page
Need help?
General
