Rim Drive Trainer
RDA2429
Instructions Manual
Read this instructions carefully before use for your safety
(ver.1.1 2014/8)
MADE IN JAPAN
MINOURA Japan Headquarters MINOURA North America
(for ALL customers, including Canada) (for the customers in the U.S.A. ONLY)
1197-1 Godo, Anpachi, Gifu 503-2305 Japan Hayward, California, U.S.A.
Phone: +81-584-27-3131 Phone: 1-510-538-8599
Fax: +81-584-27-7505 Fax: 1-510-538-5899
Email: minoura@minoura.jp Email: support@minourausa.com
Web: www.minoura.jp
Important Notes
• Only for normal 2-wheel bicycle with 110 – 170mm rear hub. Any internal transmission rear hub
cannot be used on RDA2429.
• Adjust side pressure on roller wheels to have equal contact against the rim.
• We strongly suggest you use the supplied skewer to guarantee a proper t with our trainer.
• The roller wheels have been specially designed to work with a wide variety of disc rims but we
cannot guarantee 100% compatibility.
If you have any questions or need help, you should contact the dealer where you purchased or the Minoura
distributor in your country rst. The distributor can be found on our web site.
Only when you cannot get enough service from them, you can contact us;
Contact
Warranty Period 1 year
from purchase
Applicable Tire Size
24-inch – 29-inch / 650c – 700c (Max = 29 x 2.55")
To Next Page
Need help?
General
