PAGE 19
Using the Pro-Clean Reservoir Pad
The Pro-Clean Reservoir Pad dispenses liquid as Mint Plus mops to
keep the cleaning cloth wet longer.
Empty any remaining uid from the reservoir.
Leave the ll cap open to allow reservoir to dry completely. Do not store the pad on
Mint Plus if wet.
See page 23 for care instructions.
Notice: To avoid the Pro-Clean Reservoir Pad leaving excess
uid on your oor, do not leave Mint Plus unattended when
mopping and remove from oor once Mint Plus stops cleaning.
Tip: Fluid dispenses at different rates depending on oor type and solution
used. The rst time you mop, start with the cloth only slightly damp and then
increase the starting cloth wetness if needed.
Fill the reservoir
Open the ll cap by pulling and swiveling
it to the side.
Fill reservoir with water and replace ll
cap, pressing it in securely so it does not
leak. Visit www.mintcleaner.com for infor-
mation about other cleaning solutions.
Fill the reservoir over a sink as a small
amount of uid can leak out when the ll
cap is closed.
Dampen the blue Pro-Clean microber
cloth and press onto the velcro strips.
When mopping is finished:
To Next Page
Loading...