Mint 4200

PAGE 31
Trouble Shooting
Solution
If the red light turns off after the 3 beeps, but occurs again when you press the
Sweep or Mop button, Mint Plus is not ready to clean due to an activated sensor.
Check to make sure:
Both ends of the cleaning cloth are securely tucked into the blue gripping strips
or onto the Pro-Clean velcro strips and the cloth is not bunching up.
The cleaning cloth is not in the middle channel of the removable
cleaning pad.
The removable, magnetic cleaning pad is rmly reattached to Mint Plus.
Press Mint Plus’s power button for 5-6 seconds to power it off.
Manually rotate both of Mint Plus’s wheels and set Mint Plus on the oor.
Power Mint Plus back on.
If the red light is gone, press the Sweep button to conrm Mint Plus can now
drive forward.
If the red light persists or recurs, contact customer support.
Mint Plus has encountered a problem in its environment and needs help.
Problems could include getting physically stuck or being unable to nd its
way out of a conned area.
Mint Plus will also periodically play a two-tone distress sound to alert you
it needs help.
Remove Mint Plus from its situation.
Mint Plus will go into Pause mode when moved.
Place Mint Plus back on the oor near the Cube where it started.
Press the blinking cleaning mode button to resume cleaning.