3. Operating Instructions
1. When microphone is switched on:
At the moment of the power is switched on, the indicator will flash briefly indicating
normal operation.
(a) When power on:
SIGNAL LED indicator of receiver glows.
(b) After power on:
More LED indicators shows received signal strength is strong.
(c) During Usage:
AUDIO LED displays received AF level from the microphone.
(d) When the microphone is not in use:
Make sure the power of the microphone is off. If the microphone will not be
used for some time, please remove the batteries from the battery
compartment to avoid battery leakage and result in damaged battery springs
and circuit. If a rechargeable battery was used, take it out and recharge it.
Under normal operation, when receiver and transmitter are paired together to set
frequency, microphone indicator (2) will remain off after ACT setup the frequency.
However, if indicator (2) is flashing, it means receiver and transmitter are not in the
same frequency band. Please check the stickers on transmitter and receiver to observe
if they are sharing the same frequency bands.
4. Cautions
HANDHELD WIRELESS MICROPHONE
Operating Manual
- 20 -
To Next Page
