Need help?Do you have a question about the Mira Advance ATL J97A and is the answer not in the manual?
General| Product Type | Electric Shower |
|---|---|
| Temperature Control | Thermostatic |
| Installation Type | Wall Mounted |
| Inlet Connection | 15 mm compression |
| Maximum Static Pressure | 10 bar |
| Maximum Pressure | 10 bar |
| Warranty | 2 years |
| Water Connection | 15mm |
| Water Entry Points | Top, Bottom, Rear |
| Cable Entry Points | Top, Bottom, Rear |
| Outlet Connection | 1/2 inch BSP male |
| Minimum Running Pressure | 0.7 bar |
| Controls | Push button |
| Features | Phased shutdown |
| Safety Features | Overheat protection, pressure relief |
| Hose Length | 1.25 meters |
| Finish | White |
| Safety Cut-Out | Yes |
Highlights critical safety precautions for installation and use.
Details plumbing requirements, jointing, and connection to mains cold water.
Details electrical installation requirements, earthing, bonding, and circuit protection.
Includes soldering, flushing pipework, and warnings about inlet filter flushing.
Critical procedure to prime the appliance using the air bleed button.
Step-by-step guide to wirelessly register the drain pump to the shower.
Procedure to set the maximum temperature and run the initial learning cycle.
Guidelines for tradespeople on safely troubleshooting the shower unit.
Step-by-step process for diagnosing and rectifying shower faults.
Detailed steps for performing in-service tests on the shower unit.
To Next Page
