Need help?Do you have a question about the Mira 415 and is the answer not in the manual?
General| Temperature Control | Thermostatic |
|---|---|
| Installation | Professional Installation Recommended |
| Product Type | Shower |
| Mounting | Wall Mounted |
| Outlet Connection | 1/2" BSP |
| Water Pressure | Low pressure |
Highlights product safety when installed and used correctly, and advises on assistance for users.
Provides essential warnings and cautions, emphasizing reading and retaining all instructions.
Outlines plumbing installation compliance with regulations and the need for registered professionals.
Details compliance with byelaws, BS6700, and recommendations for professional installation.
Illustrates and describes suitable plumbing systems for gas-heated showers using the Mira 415.
Explains installation with unvented, stored hot water cylinders and necessary pressure requirements.
Describes using the Mira 415 with thermal store systems and the need for a pressure reducing valve.
Instructions for removing the backplate, marking, drilling, and securing it to the wall.
Details on attaching the shower control body to the backplate and fitting inlet elbows.
Step-by-step assembly of compression fittings for inlet connections.
Instructions on how to reset the adjustable maximum temperature stop for user preference.
Continues instructions for checking and adjusting the maximum temperature stop for optimal performance.
Identifies causes and remedies for a shower that is not hot enough.
Addresses causes and remedies for significant temperature variations during showering.
Addresses causes and remedies for issues like too strong force, no hot water, or flow drops.
Identifies causes and remedies for failure to shut off or insufficient flow from the shower head.
Outlines the initial steps for replacing the shower cartridge, including water isolation.
Continues cartridge replacement steps, including fitting the new cartridge and securing the cover.
To Next Page
