4
Kaleido-X16 Installation
Kaleido-X16-S
1
The rear connector panel for this model is displayed, below:
In addition to the difference in the number of output heads, the Audio I/O TBA pinout is different between
the two models (see “Audio I/O TBA” on page 16 for details).
Kaleido-X16-S
There is one head (Head 1) on the single-head Kaleido-X16 (Kaleido-X16-S). The Input and Output
connections are as follows.
The rear connector panel for this model is displayed, below:
In addition to the difference in the number of heads, the Audio I/O TBA pinout is different between the two
models (see “Audio I/O TBA” on page 16 for details).
Connector Number of connectors on Head 1 Number of connectors on Head 2
MV OUT 1 1
SDI OUT 1 1
DVI IN 1 1
Connector Number of connectors on Head 1
MV OUT 1
SDI OUT 1
DVI IN 1
No Head 2 connectors
(DVI IN2, SDI OUT2, MV OUT2)
To Next Page
Loading...
