Standard Connection
Connecting The Loudspeakers
Choose a suitable length of twin core speaker cable for each channel and prepare the ends.
Unscrew each terminal a few turns. Connect the red, positive (+) terminal of the Left loudspeaker
to the corresponding red, positive (+) amplifier terminal.
Connect the black, negative (-) terminals similarly. Tighten the terminal securely. Repeat this
procedure for the Right Channel.
Looking After Your Loudspeaker
These speakers are hand-finished with a varnish coating. As with all real wood furniture finishes;
exposure to direct sunlight, heat, cold and varying humidity can aect the natural properties of
the speaker cabinet. We advise protecting the speaker from extreme variances in temperature
and environmental conditions.
We advise that you do not place anything on the surface of the cabinets, to protect from damage.
Treated with care, the veneer finish will last a lifetime. They will age naturally and subtly, retaining
the properties of the beautiful high gloss wood finish.
Your Mission loudspeakers use a specially hardwearing sealed finish. They should not be waxed or
treated with spray polishes which will smear and dim their lustrous finish. Polish them with a dry
or barely moist cloth to remove dust and finger marks, etc.
Occasionally, remove the loudspeaker grilles and brush them gently with a soft brush before
replacing them carefully.
Avoid getting any liquid behind the grille. If you accidentally spill liquid on your loudspeakers, take
them to your dealer for attention before using them again.
Introduction
Important
Safety Instruction
Positioning The
Loudspeakers
Connecting The
Loudspeakers
Warranty Coverage Specifications
6
To Next Page
Loading...
