2.INSTALLATIONINSTRUCTIONS(continued)
ELECTRICALINSTALLATION
WARNING
THIS RANGE HOOD MUST BE PROPERLY GROUNDED. TURN OFF ELECTRI CAL POWER AT SERVICE
ENTRANCEBEFORE WIRING.MAKE SURETHATTHEELECTRICCORDIS NOTINCONTACT WITH THE
SHARPEDGESOFTHEAPPLIANCE.
IMPROPER GROUNDING CAN RESULT IN A RISK OF ELECTRIC SHOCK. CONSULT A QUALIFIED
ELECTRICIANIFTHEGROUNDING
INSTRUCTIONSARENOTCOMPLETELYUNDERSTOODORIFDOUBT
EXISTS AS TO WHETHER THE APPLIANCE IS PROPERLY GROUNDED.DO NOT USE AN EXTENSION
CORD. IF THE POWER SUPPLY CORD IS TOO SHORT, HAVE A QUALIFIED ELECTRICIAN INSTALL AN
OUTLETNEARTHEAPPLIANCE.
RISKOFELECTRICSHOCK.THISAPPLIANCEMUSTBE
GROUNDED.
Intheeventofanelectri calshortcircuit,groundingreducestheriskofel ectric shockbyproviding
anescapewirefortheelectriccurrent.Thisapplian ceisequippedwithacordhavingagrounding
wirewithagroundingplug.Theplugmustbeconnectedtoanindepe ndentoutlet
thatisproperly
installedandgrounded.
A110‐120‐volt,60Hz,AC‐only,fusedelectricalsupplyisrequiredona separate15‐ampcircuit,
fusedonbothsidesoftheline.
Donotgroundtoagaspipe.
The ra nge hood should be connected directly
to the fused disconnect (or circuit breaker) box
throughflexiblearmoredornon‐metallicsheathedcoppercable.A U.L.‐orC.S.A.‐listedstrain
relief must be provided at each end of the power supply cable. Do not use extension cord or
adapterplugwiththis appliance.
Settheelectr ical
powersupplywithinthespacecoveredbythedecorativechimney.
Positiontheoutletoffsetsothatthepowercordwillnotinterferewiththeroundduct.
Makesurethisdoesnotinterferewithamountingbracketfasteningareaorwiththedecorative
chimney(wherethechimneytouches
thewall).
IMPORTANT
Itisthecustomer’sresponsibility,t
ocontactaqualifiedelectricalinstaller.Pleasemakeassurethat
theelectricalinstallationisadequateandis conformwithNationalElectricalCode, ANSI/ NFPA70—
latestedition*, or CSA StandardsC22. 1‐94,Canadian Electrical Code, Part 1 and C22. 2 No. 0‐M91‐
latestedition**andalllocalcodes
andordinances
8
To Next Page
Loading...
