Mistral MBM604 - Troubleshooting Guide; Operational Issues and Error Codes

14
Troubleshooting
Questions
and
answer
on bread
maker
Problem Cause Solution
Smoke comes
out of the baking
compartment or of
the vents
The ingredient stick to
the baking compartment
or on the outside of the
baking pan
Pull out the plug and clean the
outside of the baking pan or the
baking compartment
The bread goes
down in the middle
and is moist on the
boom
The bread is left to long in
the pan after baking and
warming
Take the bread out of the baking
pan before the warming function
is over
It is diicult to take
the bread out of the
baking pan
The boom of the loaf
is stuck to the kneading
paddle
Clean the kneading paddle
and shaft after the baking.if
necessary,ll the baking pan with
warm water for 30 minutes,then
the kneading paddle can be
easily removed and cleaned.
The ingredient
are not mixed or
bread is not baked
correctly
Incorrect program seing Check the selected menu and the
other seings
The Start/Stop buon
was touched while the
machine was working
Do not use the ingredients and
start over again
The lid opened several
times while the machine
was working
Do not open the lid during
operation and allow it to
complete it cycle
Power blackout while the
machine was working
Do not use the ingredients and
start over again
The rotation of kneading
paddle has ceased
Check if kneading paddle’s
rotation is obstructed by grains
etc.Take out baking pan , remove
obstructions around paddle and
ensure drive shaft rotates freely.
The appliance
does not start,The
display shows HHH
The appliance is still hot
after the previous baking
procedure
Pull out the plug, take out the
baking pan and leave it to cool at
room temperature,then insert the
plug and start again
The appliance
does not start,The
display shows L LL.
The temperature inside is
too low (accompanied by
5 beep sounds).
Stop sound by pressing the
START/STOP buon, open the
lid and let the machine rest for
10 to 20 minutes to return to
room temperature, or select the
BAKE program and make the
temperature inside the chamber
increase rapidly.
The appliance
does not start,The
display shows E rr
The temperature sensor is
disconnected.
Need check the sensor carefully
by Authorized expert.