Mistral MFHGAM - Operation

6
Your Fan Heater
Congratulationsonthepurchaseofyournew
Fan Heater.
BeforerstusingyourFanHeater,itismost
important that you read and follow the
instructionsinthisuseandcarebooklet,evenif
you feel you are quite familiar with this type of
appliance.
Your attention is drawn particularly to the section
dealingwithIMPORTANTSAFEGUARDS.Finda
placeandkeepthisbooklethandyforfuture
reference.
Your designed to function quietly and safely
under normal circumstances.
This quality Fan Heater is fully portable, with
sturdy base and a modern design.
Operation
Whenoperatedforthersttime,theunitmay
emit an unpleasant burning type smell. This is
normal, and will disappear after a short period
of use.
1. Carefullyremovetheheaterfromtheplastic
bag and carton.Place the heater on a level
surfaceinastableuprightposition.Make
certainthepowerswitchisinthe“OFF”
position.
2. Unwind the power cord and plug your Fan
Heaterintoasocketoutlet.Ensurethatthe
voltageonthespecicationsplateisthe
same as in your home.
3. Switch on the heater to the heating level
your prefer.Turn the thermostat dial fully in a
clockwisedirectiontothemaximumsetting.
WARNING: Allow the heater to cool down
for 30-60 seconds before switching on
again and before turning off at the power
outlet. This will protect the inner parts.
NOTE: It is normal when the heater is turned
on for the rst time or when they are turned
on after having not been used for a long
period of time to emit some smell and
fumes. This will disappear when the heater
has been on for a short while.
Thermostat Dial
Tondtheidealthermostatsettingforyou,rst
set the dial to maximum position. As soon as the
temperature is comfortable, turn the thermostat
to the direction of minimum position slowly, until
the heater goes off.
Power Switch Setting
OFFSetting
Fan Setting
(Without Heating)
Low Heat Setting
(1200W)
Full Heat Setting
(2400W)
This switch engages both fan and heater,fan
speed can not be altered and will always
remain constant. To use this appliance as an
air circulator Fan only, set the power switch to
“ “ setting.
LOW Setting
TheLOW“I”setting,powers1200Wtotheheater
elements. This setting is best suited to smaller,
well insulated areas that require less warming to
maintain temperature.
HIGH Setting
TheHIGH“II”setting,powersfullheat(2400W)to
the heating elements; delivering rapid warming
airtoquicklyincreasethetemperatureina
given area. To avoid overload situations, it is
recommended that no other appliances are
used at the same time on the same power
outlet.