Mistral MFHGAM - Care and Cleaning; Technical Specifications

7
CareandCleaning
• Before cleaning, ensure that the heater is
switched in the off position and is unplugged
fromthesocket.
• Cleantheexteriorsurfacesoftheheaterwith
a dry, soft cloth.
• Neveruseanyformofdetergentsorsolvents
to clean the heater.
• Neverspraywithliquidsorsubmergeinliquids
or water.
• DONOTattempttocleantheinteriorofthe
heater.
• DONOTATTEMPTTOOPENTHECASEOFTHIS
HEATERatanytime.Therearenoconsumer
serviceable parts inside this unit.
• When the heater is stored during the off
season, neatly wind the power cord around
the base of the heater to prevent any
damage to the power cord.
Note: If the power cord of the appliance
becomes damaged discontinue use.
Thermal Cut-Out
AThermalCut-Outisbuiltintothisheaterto
minimisetheriskofoverheatingandmaximise
safety to users. A heat sensing device monitors
internal temperatures in the appliance. If heat
levels rise beyond a preset safety threshold
theCut-Outwillswitchoffpowertotheheat
elements, eliminating further danger. Let the
heatercoolforapproximately10minutes,thenit
will function normally again.
IntheeventofaThermalCut-Outcheckfor
visible obstructions to air inlets. Try moving
the appliance to a new position. Sometimes
placement close to walls and furniture can
restrict air movement enough to cause the
heater to shut down.
Safety Tip-Over Switch
Thisapplianceisttedwithasafetytip-over
switch which automatically turns the unit off
when it is tilted or tipped over. Always ensure that
theunitisplacedonatsolidgroundbefore
operating.
Technical
Specications
PowerSupply:AC220-240V~50Hz
PowerConsumption:2100-2400W
Dustproof&Waterproofprotectionratingclass:
IP21
NOTE: As a result of continual
improvements, the design and
specications of the product within may
differ slightly to the unit illustrated on the
packaging.