Mistral MPAC1600R - Maintenance and Drainage; Water Drainage Procedures

23
Water drainage method
•
Manual Draining
Water may need to be drained in high humidity areas
1.
2.
3.
4.
5.
6.
Continuous Draining
While using the unit in dehumidier mode, continuous
drainage is recommended.
1.
2.
3.
14.
5.
Note
•
When there is excess water condensation inside the unit, the appliance stops running and
shows “ ”(FULL TANK as mentioned in SELF-DIAGNOSIE). This indicates that the water
condensation needs to be drained using the following procedures:
Unplug the unit from power source.
Place a drain pan under the lower drain plug.
See diagram.
Remove the lower drain plug.
Water will drain out and collect in the drain pan
(not supplied).
After the water is drained, replace the lower drain
plug rmly.
Turn on the unit.
Unplug the unit from the power source.
Remove the drain plug. While doing this operation
some residual water may spill so please have a pan
to collect the water.
Connect the drain hose (1/2" or 12.7mm, maybe not
supplied ). See diagram.
The water can be continuously drained through the hose into a oor drain or bucket.
Turn on the unit.
Please be sure that the height of and section of the drain hose should not be higher than
that of the drain outlet, or the water tank may not be drained.
Drain Outlet
Drain Cap
Fig. 24
Drain Outlet
Drain Cap
Drain Hose
Fig. 25