25
CLEANING AND MAINTENANCE
•
Cleaning the Cabinet
•
•
•
•
Cleaning the Air Filters
•
•
•
•
Start-End of Season Operations
Start of Season Checks
•
•
End of Season Operations
•
•
•
Strictest operation environment
•
•
Before cleaning or maintenance, turn the appliance o by pressing the Power button on the
control panel or remote control, wait for a few minutes then unplug from the mains socket.
Clean the appliance with a slightly damp cloth then dry with a dry cloth.
Never wash the appliance with water. It could be dangerous.
Never use petrol, alcohol or solvents to clean the appliance.
Never spray insecticide liquids or similar.
To keep your appliance working eciently, clean the lter every
month of operation. The lter can take out like g to the right.
To avoid possible cuts, avoid contacting the metal parts of the
appliance when removing or re-installing the lter. It can result in
the risk of personal injury.
Use a vacuum cleaner to remove dust accumulations from the
lter. If it is very dirty, immerse in warm water and rinse a number
of times. The water should never be hotter than 40˚C.
After washing, leave the lter to dry then attach the intake grille to the appliance.
Make sure the power cable and plug are undamaged and the earth system is ecient.
Follow the installation instructions precisely.
To empty the internal circuit completely of water,
remove the cap.
Run o all water left into a basin. When all the water has
been drained, put the cap back in place.
Clean the lter and dry thoroughly before putting back.
Cooling mode: 18 - 35˚C, 30%RH~90%RH
Heating mode: 10 - 25˚C, 30%RH~90%RH
Drain Outlet
Drain Cap
To Next Page
Loading...
