34
3.2.8 ETHERNET PORT REMOTE OPERATION SCREENS
If not already displayed, use the Up and down arrow keys to access the Ethernet Port
remote operation screens. The Ethernet port remote operation screens allow the
operator to configure the Ethernet settings listed below. These are presented in two
consecutive screens.
• Ethernet IP Address
• Ethernet Subnet Mask
• Ethernet Gateway
• Ethernet Password
NOTE: With the exception of Ethernet Password, the entry of all Ethernet Parameters
requires a system reset in order to invoke the changes. The screen above will appear
after any change. This screen gives the operator the option to defer the reset until all
Ethernet parameters have been updated. Select “YES” and Press “ENTER” to re-start
the NSU. Select “NO” and press “ENTER” to dismiss the screen and enter other
Ethernet parameters.
To change the Static IP Address:
• Press the left or right arrow key to select the IP Address field on the display.
• Use the numeric entry keys to enter each octet of the IP Address and the decimal
point to advance to the next octet. If no changes are required for a particular octet
simply press the decimal point to advance to the next octet.
• Press “ENTER” to save the IP Address.
↑
STATIC IP ADDRESS: 192.168.001.001
↓
ETHERNET SUBNET MASK: 255.255.255.000
A RESET IS REQUIRED TO ACTIVATE CHANGES
RESET NOW?
→
YES NO
To Next Page
Loading...