Power Cable
- It is designed to connect the device to an electrical outlet.
Power Connection Cable
- It is designed for electrical connection to another device.
- When using multiple devices, plug it to the device plugged into an electrical outlet
with the power cable, and then plug it into the next device. Connect each additional
device using the connection cable. The power limit of your electrical outlet
determines the maximum number of devices you can connect in this way.
Protective Glasses
- According to customer feedback, most users do not use protective glasses and
only keep their eyes closed during shining. However, always wear protective glasses
unless otherwise instructed by your physician.
Hanging System
- Eye screw, dowel
▪ It is designed to be mounted in a wall as a xed point for hanging the device.
▪ Drill a hole in a wall with sucient load-bearing capacity, insert the dowel, and
screw in the eye screw.
- Adjustable door hook
▪ It is designed to be mounted on a door as a xed point for hanging the device.
▪ Attach the door hook to an open door from above and tighten it with a thread
to secure it in place.
- Steel cables with threads and carabiner, double-sided screws
▪ It is designed to connect the device to the pulley with a rope for hanging
the device or to connect two devices underneath.
▪ Pulley connection - Screw the double-sided screws into the threads on the top
of the device and then screw the steel cables' threads onto them.
▪ Devices connection - Screw the double-sided screws into the bottom device's
top threads. Then, place these screws into the holes of the upper device,
securing them by tting the cut-outs into the tighter parts of the holes to
secure the device in place.
- Pulley with rope and carabiners
▪ Hook the pulley's carabiner to the door hook or eye screw. Then, attach the
second carabiner to the one on the steel cables.
▪ Adjust the carabiner to set the desired height for the hanged device.
Accessories
To Next Page
Loading...
